Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 11 - Jul 16
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Matek H743-Slim V4 Flight Controller - 30x30mmMatek H743 Slim V4 is a high end flight controller designed for freestyle and long range drones powered by 28S LiPo batteries. It offers wide compatibility with Betaflight, iNav, and ArduPilot firmware. The board is built around the powerful H743 processor combined with two ICM42688P gyroscopes for precise motion data and a DPS368 barometer for altitude measurement. For analog video, it includes an OSD chip and a microSD slot for Blackbox logging.
Matek H743-Slim V4 is a high-end flight controller designed for freestyle and long-range drones powered by 2–8S LiPo batteries. It offers wide compatibility with Betaflight, iNav, and ArduPilot firmware. The board is built around the powerful H743 processor combined with two ICM42688P gyroscopes for precise motion data and a DPS368 barometer for altitude measurement. For analog video, it includes an OSD chip and a microSD slot for Blackbox logging.
What is new on the H743-slim-V4
- Increase the output current of BEC5V from 2A to 2.5A, and raise the filtered VBAT current from 1A to 2A.
- Add TVS protection on Input voltage
- Add protections on more MCU I/O.
- Replace DPS310 with DPS368(environmentally protected against water (IPx8), dust & humidity)
- Other functions, Pins/Pads layout are same as previous board version.
Check out all our 30x30mm Flight Controllers and the rest of our Matek Products!
Betaflight / Inav Mapping Details
ArduPilot Mapping Details
Specifications
- MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
- IMU: Dual ICM42688P
- Baro: DPS368
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD card socket
- 7x Uarts (1,2,3,4,6,7,8) with built-in inversion.
- 13x PWM outputs(including “LED” pad)
- 2x I2C
- 1x CAN
- 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2)
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- 1x SPI3 breakout
- USB Type-C(USB2.0)
- 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
- 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
- Dual Camera Inputs switch
- 5V 0r Vbat(2A) filtered power ON/OFF switch
- DJI FPV OSD is supported by any spare UART
Power
- Vbat Input: 6~36V (2~8S LiPo) with TVS protection
- BEC: 5V 2.5A cont. (Max.3A)
- LDO 3.3V: Max.200mA
- VBat filtered output 2A for VTx and camera
- No Current Sensor built-in
- ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K)
- Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
FC Firmware
- ArduPilot: MATEKH743
- BetaFlight: MATEKH743
- INAV: MATEKH743
Physical
- Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
- Dimensions: 36 x 36 x 5 mm
- Weight: 7g
Package Includes:
- 1 x H743-SLIM-V4
- 6 x Silicon grommets M4 to M3
- 1 x JST-SH1.0_8pin cable, 5cm
- 2 x JST-SH1.0_8pin connectors
- 1 x JST-GH-4P to JST-GH-4P cable for CAN port, 20cm
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.9 ★★★★★
Based on 1754 reviews
Sort
Product Reviews
★★★★★ 5
Easy to use Plug and Play
Size: USB C to Ethernet Adapter
The item works great. I was having issues with video conference calls even with strong wifi in my house. I bought this adapter due to my HP laptop not having an Ethernet port. This worked great right out of the box. It was detected automatically and as soon as I plugged the Ethernet cable into the adapter, my laptop immediately switched over to that and my internet became more stable.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 8, 2026
★★★★★ 4
It's functional but not as fast as I expected.
Size: USB C to Ethernet Adapter
For Android phone Samsung Flagship Galaxy Series phones... at best getting 136 Mbps, which is 0.136 Gbps. But it is working and allowing me to transfer files within my network. No where near a Gigabit transfer.
I will likely keep it because I have another use case for it (a faulty Ethernet on a laptop) and don't get me started with the abyssal wifi speeds on laptops. This deserves at best 4 stars.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
★★★★★ 5
Great item
Size: USB C to Ethernet Adapter
Works like a charm. Easy set up.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 21, 2026
★★★★★ 5
Solid; long lasting
I use this adaptor to hard wire an ethernet internet connection straight into a Samsung Galaxy S10+ with PD (charges phone while connected). I also use an S8+ which works, too.
This is a great option for those of us who understand the dangers of being exposed to low-powered microwaves all day and night (AKA Wi-Fi). While hard wired to ethernet, you can enjoy the internet with airplane mode on, which is a big plus!
I've used several different branded adaptors (the ones without PD kill your device's battery QUICKLY) for this purpose, and this Anker outshines them all. Most other brands (I've tried Belkin, Ugreen, and some other somewhat obscure brands) work fine for a short time and then begin to get spotty, losing and regaining connection intermittently until crashing and not working at all over a short period of time, usually not longer than 3 to 4 months if you're real lucky.
However, I've had this Anker for nearly a year (10 months and change), and it's still going strong.
Now, it's not perfect. It does lose connection from time to time and then regain connection just like the others, but nowhere near as frequent, and if you are mindful of the orientation of the cords and take care not to twist or put torque on them once they're connected to a device, it usually keeps connection very nicely.
Be sure to put the device in the proper orientation through which you'll be looking at it, and THEN connect the adaptor (don't connect the adaptor and then have to roll the phone over to look at the screen, as this is the fastest way to kill the adaptor and loosen your phone's charging port).
When first attaching, I plug the ethernet cable into the adaptor and use a hair-tie rubber band to wrap around the end of the ethernet cable, making sure it's tight with no slack, then I secure it around the BASE of the type-C cable coming out of the opposite end of the adaptor (see attached picture). Then LEAVE IT. If you incessantly disconnect and reconnect this adaptor, I guarantee it will not last as long.
As for the features of this adaptor, I can only speak on the ethernet connection, the PD port, and the type-C 5gbps port.
The PD port is nice because if you try connecting to the internet and doing pretty much anything without it, your device's battery is going to drain quite rapidly. How fast depends on how good your device's battery is to begin with. S10+ probably won't last half the time without PD as it does with PD. Just realize that your device is not going to gain power while charging through the PD port, but rather the battery will merely die at a slower pace, giving you more time before having to recharge your device. The other factor is how long your charging cable is (the shorter it is, the longer the battery will last).
Tip: While using PD port, your device will not warn you of your battery about to die since it is technically charging, so if you're doing something important, you had better keep an eye on your battery percentage, lest it dies unexpectedly.
I've not used the hdmi port at all, so nothing to speak on there.
The 5gbps type-c port is nice if you want to connect an external hard drive while either A: connected to the internet, B: still being able to charge your phone, or both! I use the Samsung Portable SSD T7, and the Anker is great for saving large videos/files straight from the internet onto the external hard drive. The Anker is also good for freeing up space on your phone by moving existing files to the hard drive while continuing to charge your phone (otherwise, the hard drive connects directly to your phone, so your charging port is being used, and if your battery is low, no charging). Also, if you disconnected the ethernet cable from the Anker while moving files to an external drive, I suspect that the PD port would actually add battery percentage instead of merely slowing down the loss of battery percentage.
To summarize:
- Don't get Wi-fried: use a hard-wired ethernet connection instead!
- Great adaptor that lasts longer than all others I've tried.
- PD is a must have feature, but your device will still eventually die.
- Great for saving videos/large files straight from internet to external hard drive while being able to charge device simultaneously.
This Anker is the one you're looking for!
Cheers.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 15, 2022
★★★★★ 5
Excellent quality with just the right amount and type of connection points I needed!
Extremely good quality. I've used many Anker product over the years and this one didn't disappoint! Needed it to run a laptop on my network in isolation mode and to have accessible connections for ethernet as well as a wireless mouse and extra cooling fan as my laptop has only 1 standard size USB 3.0 port. This is the mini version so It won't necessarily supply enough juice to charge your laptop at the same time (there's another 8 in 1 made by Anker for that) but it can supply enough power to maybe get you through a very trying session, very short term. Super-easy to connect and just works. Fits comfortably in my carry bag too. Very light weight, good heat dissipation although I didn't really have any or at least not much. Compatible with all the connectors you see in the picture. In my case at least, it wasn't a luxury it was a necessity and it proved it's value immediately.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 26, 2026
recommand products
POWER VISION 3 FOR POLARIS RZR XP TURBO / PRO XP / TURBO R
235.00
Rough Country CARGO GATE REAR | POLARIS RZR PRO R 4 (2022)/RZR PRO XP 4 (20-22)
89.95
Infinite Offroad (UTV) - RGB+W Rock Light & Whip Bundle
250.00
FRONT FACING 30-INCH LED KIT POLARIS RZR PRO R (2022)
189.95
LAUNCH CONTROL MODULE FOR 2020-2021 POLARIS RZR PRO XP / TURBO R (W/SWITCH)
187.50