Jeep Wrangler TJ Aluminum Diamond Plate no cut out Rockers & Fender Bend set

Jeep Wrangler TJ Aluminum Diamond Plate no cut out Rockers & Fender Bend setFITS 1997 TO 2006, ROCKERS AND FENDER TOPS ARE BOTH LEFT AND RIGHT SIDES PLEASE NOTE: WILL NOT FIT THE JEEP UNLIMITED OUR ROCKERS RUN A FULL 5 3 4 INCHES TALL AND HAVE CUT OUTS FOR FENDER EXTENSIONS AND FENDER TOPS ARE 40 INCH LONG AND COMES WITH 1 2 INCH BEND. BOTH ARE MADE OF 3003 HIGHLY POLISHED SHOW QUALITY ALUMINUM DIAMOND PLATE. PLEASE NOTE: TO INSTALL TUCK ROCKERS UNDER FENDER FLARES ON BOTH ENDS, HOLD OR CLAMP INTO PLACE, DRILL A 1 8" HOLE AND

FITS 1997 TO 2006, ROCKERS AND FENDER TOPS ARE BOTH LEFT AND RIGHT SIDES

PLEASE NOTE:  WILL NOT FIT THE JEEP UNLIMITED

 OUR ROCKERS RUN A FULL 5 3/4 INCHES TALL AND HAVE CUT OUTS FOR FENDER EXTENSIONS AND FENDER TOPS ARE 40 INCH LONG AND COMES WITH 1/2 INCH BEND. BOTH ARE MADE OF 3003 HIGHLY POLISHED SHOW QUALITY ALUMINUM DIAMOND PLATE. PLEASE NOTE: TO INSTALL TUCK ROCKERS UNDER FENDER FLARES ON BOTH ENDS, HOLD OR CLAMP INTO PLACE, DRILL A 1/8" HOLE AND INSTALL RIVETS. FENDER TOPS REMOVE HOOD LATCH AND RUBBER STOPS, LINE UP THE FENDER TOP WHERE YOU WANT IT FOR BEST FIT AND LOOK. MARK HOOD LATCH HOLES & RUBBER STOPS FROM UNDERSIDE WITH MARKER AND REMOVE. DRILL THE HOLES YOU MARKED WITH A 1/4 INCH DRILL BIT FOR THE HOOD LATCH BOLTS, REINSTALL THE HOOD LATCH, YOU CAN DO THE SAME FOR THE RUBBER STOPS IF YOU WANT TO INSTALL THEM. CAN BE INSTALLED WITH SCREWS OR RIVETS  OR YOU CAN USE RTV CAULK, 2 SIDED TAPE.